|
4 Wheel Aligner -
Computer Wheel Aligner |
The 8-sensor
“Around the Car” measurement optimises 4-Wheel
alignment
|
The
V-Tech 618i is a new generation of Wheel
Alignment. All angles are measured by means of the
8-sensor CCD camera system with a measuring range
of +/- 25 degrees - we call it 20/20 vision. No
electronic turntables are needed since the caster
swing is measured at 10, 14 or 20 degrees for high
accuracy by use of the CCD camera. |
|
Measurements and adjustment illustrated in
Super VGA colour.
All measuring data and specifications from
before and after adjustment on one screen. |
Electronic Level displays the level on-screen
and also on the measuring head. This assures
that faults in the operation are avoided. |
|
“Around the
Car” measurement |
 AThe
Quattro measurement system has 8 Toe-sensors so
the vehicle is framed on all four sides.
It is therefore possible, besides all Toe angles,
also to measure Rear Axle Setback, Side Offset,
Axle Offset and Wheel Base.
Also a continuous check of the accuracy is
performed.
The system assures that compensation for Run-Out
is performed continuously. Even when the wheels
are rotating after compensation is done all angles
is measured correctly.
During compensation the level is shown on-screen. |
The Operator program
The software is a very important feature of the
wheel aligner – OPTO-PLUS stands for simple design
and easy to operate – therefore the OPTO-Win
(software for OPTO-PLUS wheel aligners) is simple
in design and very easy to use. The OPTO-Win
offers a simple procedure that all mechanics can
operate after a 5-minute introduction. Even
mechanics that has tried the OPTO-Win once and
returning after 3 months without operation can
operate the software.
|
• Databank
with more than 10.000 specifications. Changes in
existing data or data for an unlimited number of new
cars can be typed in via the keyboard.
• Program and data are stored on a hard disk. The
database is updated via the CD ROM drive.
• Adjusting of Camber and Caster with the cars in
lifted up position so it is easier to adjust specific
car models.
• Customer databank with complete records of earlier
measurements.
• Measurements result from before and after
adjustment.
• Casterswing on 100 , 140 and 200 can be selected.
• Equipment can be controlled from all 4 measuring
heads.
• On-line Pop-Up Help for all measurement and system
functions.
|
